Makita HR2010 Technical Information page 6

To avoid abrasion at earlier stage and heating damage, use the MAKITA grease R No. 00 to grease on the
points shown below.
1) Outer circumference of pin5
2) Each teeth face of Helical gear 43, Helical gear 29, spiral
bevel gear 9 and spiral bevel gear 33
3) Cam of spiral bevel gear 33 and cam of clutch cam
4) Flat washer 8 Both edges on flat washer 23
5) Lip face of oil seal 20
6) Needle bearing 810
(3) Necessary tools
1) + screw driver
2) - screw driver
3) Arbor press
4) Resin hammer or wooden hammer
5) Radio cutting plyer
6) Sharpened-edge tool like an eyeleteer
7) O ring inserting jig
Teeth face
Both edges
Lip face
Outer circumference
Teeth face
Teeth face
Cam
Cam