Replacing The Lcd Panel - Dell XPS M2010 Service Manual

1 LCD panel
22. To remove the rails from the LCD panel, remove two M2 x 3-mm screws from the top rail, four M2 x 3- mm screws
from the right rail (marked "R"), and four M2 x 3-mm screws from the left rail (marked "L").
The bottom rail is adhered to the LCD panel. Reserve the other three rails to attach to the new LCD panel.
1 M2 x 3-mm screws (10)
4 top rail

Replacing the LCD Panel

1. Attach the rails from the old LCD panel to the new LCD panel using two M2 x 3-mm screws in the top rail, four M2 x 3-
mm screws in the right rail (marked "R"), and four M2 x 3-mm screws in the left rail (marked "L"). Ensure you have
"This side up" facing up on all three rails.
If a bottom rail is not attached to the new LCD panel, adhere a bottom rail to the new panel.
2. Holding the LCD panel over the display, connect the LCD cable to the connector on the display.
3. Lower the LCD panel into place and attach the rails to the display using four M2 x 3-mm screws in the right rail, four
M2 x 3-mm screws in the left rail, and two M2 x 3-mm screws in the bottom rail.
2 LCD cable
2 left rail
5 right rail
3 pull tab
3 LCD panel