Table of Contents
Advertisement
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
Media and Additional Parts
Description
Parts Catalog
Operator's Manual
Certificate of Compliance
O-ring
Screws
Note: Determine the left and right sides of the machine
from the normal operating position.
1
Inspection
Parts needed for this procedure:
1
Cutting unit
Procedure
After the cutting unit is removed from the box, inspect the
following:
1. Check each end of the reel for grease. Grease should
be visibly evident in the reel bearings and internal
splines of the reel shaft.
2. Ensure that all nuts and bolts are securely tightened.
Description
Cutting unit
No parts required
No parts required
No parts required
Tipper roller kit (not included)
Fixed plate kit (not included)
Qty.
1
–
–
–
1
1
Qty.
1
Use to reference part numbers
1
Review the manual and save in an appropriate place
1
CE compliance
1
Use when mounting reel motor to cutting unit
2
Use to mount reel motor to cutting unit
3. Make sure the carrier frame suspension operates freely
and does not bind when moved back and forth.
2
Cutting Unit Kickstand
No Parts Required
Procedure
Whenever the cutting unit has to be tipped to expose the
bedknife/reel, prop up the rear of the cutting unit with the
kickstand (supplied with the traction unit) to make sure the
nuts on the back end of the bedbar adjusting screws are not
resting on the work surface (Figure 3).
4
Use
Inspect the cutting unit
Use the kickstand when tipping the
cutting unit
Adjust the rear shield
Mount the counter weights
Install the optional tipper roller kit
Install the Optional Fixed Plate Kit
Use
Advertisement
Table of Contents
