Table of Contents
Advertisement
1. Cutting unit kickstand
3
Adjusting the Rear Shield
No Parts Required
Procedure
Under most conditions, best dispersion is attained
when the rear shield is closed (front discharge). When
conditions are heavy or wet, rear shield may be opened.
To open the rear shield (Figure 4), loosen the cap screw
securing the shield to the left side plate, rotate the shield
to the open position and tighten the cap screw.
Figure 3
1. Rear shield
4
Mount the Counter Weights
No Parts Required
Procedure
All cutting units are shipped with the counter weight
mounted to the left end of the cutting unit. Use the
following diagram to determine the position of the
counter weights and reel motors.
1. On the #3 cutting unit, remove the 2 cap screws
securing the counter weight to the left end of the
cutting unit. Remove the counter weight (Figure 6).
5
Figure 4
2. Cap screw
Figure 5
Advertisement
Table of Contents
