Replacing The Headlight Bulb; Replacing The Drive Belts - Toro 38657C Operator's Manual

1. Discharge chute latch
Note: The latch is spring loaded and will naturally
move into the teeth of the gear (Figure 57).
4. Remove any slack in the cable by pulling the cable
conduit rearward.
5. Tighten the bolt on the cable clamp.
6. Install and secure the gear cover.

Replacing the Drive Belts

If the auger/impeller drive belt or the traction drive belt
becomes worn, oil-soaked, or otherwise damaged, go
to www.Toro.com for additional service information or
have an Authorized Service Dealer replace the belt.
Figure 57
2. Gear teeth

Replacing the Headlight Bulb

Use a GE 892 16W halogen light bulb. Do not touch
the bulb with your hands or allow dirt or moisture to
come into contact with the bulb.
1. Remove the wire connector from the back of the
headlight (Figure 58).
2. Turn the base of the bulb counterclockwise until it
stops (Figure 59).
3. Remove the bulb straight out from the back of the
headlight (Figure 60).
4. Insert a new bulb into the back of the headlight
(Figure 61).
24
Figure 58
Figure 59
Figure 60
Figure 61