Checking The Auger Gearbox Oil Level; Changing The Engine Oil - Toro 38657C Operator's Manual

Figure 47
1. Jam nut
6. Loosen or tighten the turnbuckle that adjusts the
tension on the cable (Figure 47).
7. Adjust the turnbuckle until you obtain the proper
gap.
8. Tighten the jam nut.
9. Insert the 2 screws you previously removed on the
belt cover.
10. If the auger/impeller cable is properly adjusted but
a problem remains, contact an Authorized Service
Dealer.
Checking the Auger Gearbox
Oil Level
Service Interval: Yearly—Check the auger gearbox oil
and add oil if necessary.
1. Move the snowthrower to a level surface.
2. Clean the area around the pipe plug (Figure 48).
Figure 48
3. Remove the pipe plug from the gearbox.
2. Turnbuckle
4. Check the oil level in the gearbox. The oil should be
at the point of overflowing at the filler opening.
5. If the oil level is low, add GL-5 or GL-6, SAE 85-95
EP transmission oil to the gearbox until the point
of overflow.
Note: Do not use synthetic oil.
6. Install the pipe plug in the gearbox.

Changing the Engine Oil

Service Interval: After the first 5 hours—Change the
engine oil.
Every 50 hours—Change the engine
oil. Change the engine oil every 25
operating hours when operating the
engine under a heavy load.
If possible, run the engine just before changing the
oil because warm oil flows better and carries more
contaminants.
Max. fill: 28 oz. (0.83 l), type: automotive detergent oil
with an API service classification of SF, SG, SH, SJ, SL,
or higher. Use SAE 5W30 or SAE 10W30 oil. Refer to
your engine owner's manual.
1. Clean the area around the oil drain cap (Figure 49).
1. Oil drain cap
2. Slide an oil drain pan under the drain extension and
remove the oil drain cap.
3. Drain the oil.
Note: Dispose of the used oil properly at a local
recycling center.
4. Install the oil drain cap.
5. Fill the crankcase with oil. Refer to Filling the
Engine Crankcase with Oil.
21
Figure 49