Using The Kickstand - Toro 03698 Operator's Manual

1
g020547
Figure 6
1. Lift arm number
2 = 38.1 cm
(15 inches)
5. On lift arm number 6 and number 7, position the
brackets and U-bolts 36.8 cm (14.5 inches) behind the
center line of the pivot knuckle
Note: Rotate the brackets 10 degrees to the outboard
side of the machine.
1
Figure 7
1. Lift arm number
6 = 36.8 cm
(14.5 inches)
6. Tighten all the U-bolt nuts to 52 to 65 N∙m (38 to 48
ft-lb).
2
2. Lift arm number 3 =
45 degrees
(Figure 7).
2
g020548
2. Lift arm number 7 =
10 degrees
7. Mount a lift chain to each chain bracket with a screw,
a washer, and a nut, positioning them as shown in
Figure 8.
1. Lift chain
4

Using the Kickstand

Parts needed for this procedure:
1 Kickstand (supplied with traction unit)
Procedure
Whenever the cutting unit has to be tipped to expose the
bedknife/reel, prop up the rear of the cutting unit with the
kickstand (supplied with the traction unit) to make sure that
the nuts on the back end of the bedbar adjusting screws are
not resting on the work surface
6
Figure 8
2. Chain bracket
(Figure 9).