How To Clear User Setting; Resetting Both Base Unit And Handset; Resetting Only H Andset - Panasonic KX-TGD320ALB Service Manual

KX-TGD320ALB/KX-TGD322ALB/KX-TGD323ALB/KZ-TGDA30AZB
8.3.

How to Clear User Setting

Units are reset to the Factory settings by this operation (Erase recorded Voice messages, stored Phone numbers, Caller list and
etc.)
Note:
• Some menus are not reset. Refer to Operating Instructions (P.20).
• The reset menus differ depending on the following operations.
• This operation should not be performed for a usual repair.
8.3.1.

Resetting both base unit and handset

Both the base unit and the registered handset which you did the following steps
will not be reset.
1
Connect the AC adaptor to the base unit and install the charged batteries into the handset.
2
Confirm the handset is registered to the base unit (
If the handset is not registered to the base unit (
3
Lift the handset and press {
4
Press 1 , 5 , 9
5
Disconnect the AC adaptor, then remove the battery.
Note:
(*1) Refer to Registering a Handset to a Base Unit in the Operating Instructions.
8.3.2.

Resetting only h andset

The only handset is reset by doing the following steps
1
Install the charged batteries into the handset.
2
Lift the handset and press {
3
Press 3 , 5 , 7
4
Remove the battery.
Note: (*2)
• The handset registration to the base unit is cancelled.
• If the handset needs to be registered to the base unit, refer to Registering a Handset to a Base Unit in the Operating
Instructions.
• If users do not bring the base unit with them, the registration procedure has to be done by users themselves.
w
Handset
} to put the handset in standby mode.
and key of the handset simultaneously until a confirmation tone is heard.
} to put the handset in standby mode.
and # key of the handset simultaneously until a confirmation tone is heard. (*2)
Base unit
lights).
lights), register it. (*1)
1
to .
Handset
26
1
5
to are reset. Other registered handsets