Using The Wall-Mounted Door Control; To Open The Door Manually - Craftsman 139.18571D Owner's Manual

Using the Wall-Mounted Door Control

The PREMIUM CONTROL CONSOLE
Press the lighted push button to open or
close the door. Press again to reverse the
door during the closing cycle or to stop
the door while it's opening.
Light feature
Press the Light button to turn the opener
light on or off. It will not control the
opener lights when the door is in motion.
If you turn it on and then activate the
opener,
the light will remain on for 4-1/2 minutes. Press again to turn it
off sooner. The 4-1/2 minute interval can be changed to 1-1/2,
2-1/2, or 3-1/2 minutes as follows: Press and hold the Lock
button until the light blinks (about 10 seconds). A single blink
indicates that the timer is reset to 1-1/2 minutes. Repeat the
procedure and the light will blink twice, resetting the timer to
2-1/2 minutes. Repeat again for a 3-1/2 minute interval, etc.,
up to a maximum of four blinks and 4-1/2 minutes.
Lock feature
Designed to prevent operation of the door from hand-held remote
controls. However, the door will open and close from the Door
Control, the Outdoor Key Switch and the Keyless Entry
Accessories.
To activate, press and hold the Lock button for 2 seconds. The
push button light will flash as long as the Lock feature is on.
To turn off, press and hold the Lock button again for 2 seconds.
The push button light will stop flashing. The Lock feature will also
turn off whenever the "learn" button on the motor unit panel is
activated.
Additional feature when used with the 3-Function
hand-held remote
To control the opener lights:
In addition to operating the door, you may
program the remote to operate the lights.
1. With the door closed, press and hold a small remote button
that you want to control the light.
2. Press and hold the Light button on the door control.
3. While holding the Light button, press and hold the Lock button
on the door control.
4. After the opener lights flash, release all buttons.

To Open the Door Manually

Push
To prevent possible SERIOUS INJURY or DEATH from a falling
Bar
garage door:
Light
• If possible, use emergency release handle to disengage trolley
Button
ONLY when garage door is CLOSED. Weak or broken springs
Lock
or unbalanced door could result in an open door falling
Button
rapidly and/or unexpectedly.
• NEVER use emergency release handle unless garage doorway
is clear of persons and obstructions.
• NEVER use handle to pull door open or closed. If rope knot
becomes untied, you could fall.
DISCONNECT THE TROLLEY:
The door should be fully closed if
possible. Pull down on the emergency
release handle (so that the trolley
release arm snaps into a vertical
position) and lift the door manually.
The lockout feature prevents the
trolley from reconnecting
automatically, and the door can be
raised and lowered manually as often
as necessary.
TO RE-CONNECT THE TROLLEY:
Pull the emergency release handle
toward the opener at an angle so
that the trolley release arm is
horizontal. The trolley will reconnect
on the next UP or DOWN operation,
either manually or by using the door
control or remote.
31
Trolley
Trolley
Release Arm
(In Manual
Disconnect
Position)
Lockout position
(Manual disconnect)
Trolley
Trolley
Release
Arm
Emergency
Release Handle
(Down and Back)
To reconnect