Advertisement
The YA-S10 Geometric Correction Box ("Control Box") can be controlled from an external device via
its LAN port.
Connection
Connect the LAN port of the Control Box to the LAN hub to which the device to be linked to via
wired LAN is connected. If this is the first time you are connecting the Control Box to a LAN (or
immediately after executing the Control Box's "Initialize Wired LAN Settings" command), connect
to a LAN that includes a device with a DHCP server function and configure wired LAN settings.
For more information, refer to "Using a Computer to Configure Control Box LAN Settings" in the
User's Guide.
In a configuration like the one in the illustration above, you should normally use straight type
LAN cables.
Supported Devices and Standards
Crestron
This Control Box supports Crestron Electronics controller and software (RoomView®) commands.
For detailed information and information about downloading RoomView®, visit the website below.
URL http://www.crestron.com/microsites/get-roomview
When using the Crestron controller, the controller IP address and other settings must be
configured on the Control Box. Settings are configured on the Crestron Control page shown below,
which appears when you click [Crestron Control] on the System Admin page.
*1 LAN hub
*2 Device with a DHCP server function
2
Advertisement
