Starting Up; Battery Installation; Power Supply - AEG CTV 4889 Instruction Manual

English
52
Remote control

battery installation

A. With the alternating
current adapter
05-CTV 4889_GB.indd 52 05-CTV 4889_GB.indd 52

Starting up

WARNING:
Leaking out battery acid can damage your health. Remove the battery
from the battery compartment as soon as it is exhausted or if the remo-
te control is not going to be used for a longer period of time. Wipe up
leaked out battery acid with a cloth. In case of skin contact immediately
wash the aff ected area. Seek medical advice if battery acid has been
swallowed.In case of contact with your eyes wash out the eyes and seek
medical advice.
ATTENTION:
Mismatching battery types or new and used batteries must never be
used together. Diff erent battery types have diff erent properties. Do not
use old and new batteries together. The mutual use of old and new
batteries can shorten the lifetime of the new batteries and possibly
result in leakage of the old batteries. When disposing of old batteries
you should strictly comply with the legal and environmental regulations
applicable in your country. Do not throw batteries into fi re!
NOTE:
The lifetime of the enclosed batteries may be shortened because of
storage.
1. Open and remove the battery compartment cover.
2. Insert two batteries of type AAA/R03 (1.5 V), ensure correct polarity
(+ and -). Start with the negative pole (-).
3. Attach and close the battery compartment cover.
NOTE:
The signals from the remote control are transmitted to the DVD-Player
by infrared light. You should therefore take care that the DVD-Player is
not exposed to the direct sunlight. This could make the transmission of
signals from the remote control to the DVD-Player impossible.
Eff ective range of the remote control
If you want to use the remote control it has to be pointed at the remote
control sensor on the front of the device. The distance between remote
control and sensor should not exceed 5 m. The angle of the remote
control to the remote control sensor to right, left, top and bottom should
not exceed 30°.

Power Supply

The alternating current adapter works with alternating current of bet-
ween 100 V and 240 V, but
In Europe the mains lead (supplied) may only be connected to an
alternating current power source of 230-240 V.
When connecting to an alternating current source outside Europe a
plug adapter must be used that conforms to the socket.
1. Insert the cable from the alternating current adapter into the DC IN
9V socket (Fig. 2/28) of the device.
08.09.2008 9:02:34 Uhr 08.09.2008 9:02:34 Uhr