For Vigor2925N - Draytek Vigor2925 Series Quick Start Manual

1
1
LED
ACT (Activity)
USB
WLAN
WAN1~WAN2
VPN
QoS
WCF
DMZ
LED on Connector
WAN1~
WAN2
LAN1~
LAN5
Vigor2925 Series Quick Start Guide
Downloaded from www.Manualslib.com
. 1 . 2 F o r V i g o r 2 9 2 5 n
. 1 . 2 F o r V i g o r 2 9 2 5 n
Status
Blinking
Off
On
Blinking
On
Blinking
On
Off
Blinking
On
On
On
On
Off
Blinking
Left On
LED
Off
Blinking
Right On
LED
Off
Left On
LED
Off
Blinking
manuals search engine
Explanation
The router is powered on and running
normally.
The router is powered off.
USB device is connected and ready for use.
The data is transmitting.
Wireless access point is ready.
It will blink slowly while wireless traffic
goes through.
ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and
will return to normal condition after two
minutes. (You need to setup WPS within 2
minutes.)
Internet connection is ready.
Internet connection is not ready.
The data is transmitting.
The VPN tunnel is active.
The QoS function is active.
The Web Content Filter is active. (It is
enabled from Firewall >> General
Setup).
The DMZ function is enabled.
The DMZ function is disabled.
The data is transmitting.
The port is connected.
The port is disconnected.
The data is transmitting.
The port is connected with 1000Mbps.
The port is connected with 10/100Mbps
The port is connected.
The port is disconnected.
The data is transmitting.
4