Bosch PLL 5 Original Instructions Manual page 22

OBJ_BUCH-311-007.book Page 22 Tuesday, May 6, 2014 1:30 PM
22 | English
Vertical Alignment (see figure D): Position the measuring tool with the
three supporting points 12 against the wall or with help of the magnets
14, fasten it to the wall holder 1 or to another magnetic surface. The exit
opening for the laser beam 9 must face upward. Align the measuring tool
vertically with help of the spirit level 6. Top and bottom cabinets, as an ex-
ample, can be aligned alongside the vertical laser line.
Alignment off of Reference Points (see figure E): Position the measur-
ing tool with the three supporting points 12 against the wall or with help
of the magnets 14, fasten it to the wall holder 1 or to another magnetic
surface. Turn the measuring tool to any angle in order to align the laser
beam to the reference points. In this manner, as an example, picture
frames can be hung parallel to a stairway or ceiling pitch.
Checking Horizontal/Vertical Lines with the Spirit Levels
(see figure F)
The measuring tool can be used as a contractors level for checking hori-
zontal or vertical lines, e.g., for the level set-up of a washer or a refrigera-
tor. Position the measuring tool with the aluminium supporting surface 8
facing against the surface to be checked. When positioning against hori-
zontal surfaces, the aluminium supporting surface 8 must face down-
ward. When positioning against vertical surfaces, the exit opening for the
laser beam 9 must face upward.
Working Advice
 Keep the adhesive tape strips 4 out of the reach of small children.
Children could mistake the strips with chewing gum.
Mounting to a Wall
Four fastening methods are available for fastening the wall holder to dif-
ferent surfaces:
– Fastening with Adhesive Tape Strips (see figure G): With the remov-
able adhesive tape strips 4, the wall holder can be fastened to sensitive
or delicate sturctural materials without causing damage to them. The
structural surface must be straight, firm, dry, grease-free and have a
temperature of at least 15 °C . Pull off one of the protective foils from
an adhesive tape strip () and position the adhesive tape strip onto
the back side of the wall holder () in such a manner that its end
1 609 92A 0JK | (6.5.14) Bosch Power Tools