Makita 6821 Instruction Manual page 7

1
A
B
1. Reversing switch lever
ASSEMBLY
1
2
1. Locator
2. Locking sleeve
1
2
1. Bit
2. Magnetic bit holder
To stop the tool from the locked position, pull the switch trig-
ger fully, then release it.
Reversing switch action
002634
This tool has a reversing switch to change the direction of
rotation. Move the reversing switch lever to the
(A side) for clockwise rotation or the
counterclockwise rotation.
CAUTION:
• Always check the direction of rotation before operation.
• Use the reversing switch only after the tool comes to a
complete stop. Changing the direction of rotation before
the tool stops may damage the tool.
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing the bit
Pull the locator out of the locking sleeve while turning the
002652
locator slightly. Then grasp the bit with a pair of pliers and
pull the bit out of the magnetic bit holder. Sometimes, it helps
to wiggle the bit with the pliers as you pull.
To install the bit, push the bit firmly into the magnetic bit
002660
holder. Then install the locator by pushing it firmly onto the
locking sleeve while turning the locator slightly.
position
position (B side) for
7