NETGEAR Arlo Quick Start Manual page 6

Sync your cameras with the base station (cont'd)
b. Press the Sync button on the side of
the base station for about two seconds.
Release the button.
c. Wait for the Sync Status LED to blink
green.
10
d. Press the Sync button on top of the
camera for about two seconds. Release
the button.
A blue LED on the camera blinks slowly
when starting the sync process. The blue
LED blinks rapidly to confirm sync.
The camera is ready for viewing.
Note:
The LED blinks amber if the sync is not
successful. You must repeat the sync process.
Syncing more than one camera?
Go to page 9 and repeat steps 5a
through 5d for each camera.
11