AEG HSM 5597 N Instruction Manual page 57

Hair and beard clippers + nose and ear hair trimmer
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 51
Inserting of the battery (Battery is not included in the scope of
delivery)
1. Turn the lower cover towards " " and remove it.
2. Insert a 1.5 V battery of the type MIGNON AA into the battery compartment. The posi-
tive pole (+) has to show towards the shaving head.
3. Close the battery compartment again: Place the marker on the cover "" to the symbol
" ". Turn the cover towards " " until it snaps audibly into place.
Usage
1. Remove the transparent protection cap.
2. Slide the switch towards "OFF" in order to turn on the appliance.
• When the switch snaps audibly into place, the appliance works continuously.
• If you release the switch before it snaps audibly into place, the appliance will switch
off again.
3. Guide the tip of the shaving head into the nostril or auricle.
WARNING:
Only remove the prominent nose or ear hair. Do not forcefully push the appliance
into the nostril / auricle. You can hurt yourself when it is inserted too deep!
4. Slide the switch back towards "ON" after usage in order to switch off the device.
5. Clean the shaving head with the cleaning brush after usage.
6. Put the transparent protection cap back on.
Cleaning
WARNING:
• Do not submerge the unit in water.
CAUTION:
• Do not use a wire brush or other abrasives.
• Do not use sharp or abrasive cleaning agents.
English
57

Advertisement

Table of Contents
loading

This manual is also suitable for:

R 5597 n

Table of Contents