Operation - Makita HS7601 Instruction Manual

BE SURE TO TIGHTEN THE HEX BOLT CLOCKWISE
SECURELY.
CAUTION:
Make sure that the protrusion "a" on the inner
•
flange that is positioned outside fits into the
saw blade hole "a" perfectly. Mounting the blade
on the wrong side can result in the dangerous
vibration.
For tool with the inner flange for a 15.88 mm hole-
diameter saw blade (country specific)
1 2
3
011231
1 2
15.88
3
014598
Mount the inner flange with its recessed side facing
outward onto the mounting shaft and then place saw
blade (with the ring attached if needed), outer flange
and hex bolt.
BE SURE TO TIGHTEN THE HEX BOLT CLOCKWISE
SECURELY.
WARNING:
Before mounting the blade onto the spindle,
•
always be sure that the correct ring for the
blade's arbor hole you intend to use is
installed between the inner and the outer
flanges. Use of the incorrect arbor hole ring may
result in the improper mounting of the blade
causing blade movement and severe vibration
resulting in possible loss of control during
operation and in serious personal injury.
1. Mounting shaft
5
2. Inner flange
3. Saw blade
4. Outer flange
5. Hex bolt
4
1. Mounting shaft
5
6
2. Inner flange
3. Saw blade
4. Outer flange
5. Hex bolt
6. Ring
4
Hex wrench storage
015325
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Connecting a vacuum cleaner
(Optional accessory)
1
2
015326
2
015327
When you wish to perform clean cutting operation,
connect a Makita vacuum cleaner to your tool. Install
the dust nozzle on the tool using the screw. Then
connect a hose of the vacuum cleaner to the dust
nozzle as shown in the figure.

OPERATION

CAUTION:
Be sure to move the tool forward in a straight line
•
gently. Forcing or twisting the tool will result in
overheating the motor and dangerous kickback,
possibly causing severe injury.
Always use a front grip and rear handle and firmly
•
hold the tool by both front grip and rear handle
during operations.
9
1. Hex wrench
1
1. Dust nozzle
2. Screw
1. Vacuum cleaner
2. Hose
1