Advertisement
Available languages
Available languages
THE TOOL LABEL MAY
HAVE THE FOLLOWING
SYMBOLS:
V
volts
A
Amperes
Hz
Hertz
W
Watts
min.
Minutes
AC power
Direct current
n
No-load speed
0
Secondary construction
Grounding terminal
Safety alert symbol
PARTS INTRODUCTION
(FIG. A, B AND C)
1. Switch (forward)
2. Switch (reverse)
3. Sleeve
4. Main shaft locking ring
5. Battery box
6. Battery box release button
7. Battery direction indication
ASSEMBLY AND
ADJUSTMENT
Remove the battery before assembly
and adjustment.
When fitting or removing the
battery, keep the fingers away from
any switch to avoid the unexpected
startup of the tools.
BATTERIES
This tool uses four AA alkaline
batteries (R6).
FITTING AND REMOVING
THE BATTERY (FIG. B)
Press the two release buttons (6) of
the battery box, and pull out the
battery box from the tool, as shown in
the figure. Install batteries into the
box according to the battery direction
indication (7) of the battery box
(positive and negative poles indicated
with ＋ and − respectively), and
then recover the battery box. Note:
Some batteries are printed with
positive symbol (＋) only, the other
6
end without the symbol is the
negative pole (−). The battery box is
designed to insert into the tool from a
single direction. If it cannot be fully
inserted, do not force it, instead, you
shall rotate the box for 180 and try
again, until you hear a "click".
Important: Improper installation of
battery will reduce the efficiency of
the tool or make it unusable. If the
battery is new, but the tool is
powerless or unable to operate,
please check if the battery is properly
installed into the battery box with
correct direction. If the battery is
properly installed, press the two
release buttons and pull out the
battery box, and then you can remove
the battery.
Fitting and removing
screwdriver bit (fig. C)
To install the screwdriver bit,
•
insert the screwdriver into the
main shaft sleeve (3) until it is in
place.
To remove the screwdriver bit,
•
pull it out of the sleeve.
If the screwdriver bit cannot
•
insert into the sleeve, rotate it
and try again.
FORWARD/REVERSE
SWITCHES (FIG. D AND E)
Rotate the main shaft locking ring
•
(4) to the position with
"power" characters.
Press the forward switch (1)
•
marked with
rotate in forward direction.
Release the forward switch, the
tool will stop.
To make the tool rotate in reverse
•
direction, first rotate the main
shaft locking ring (4) to the
position with
characters. Press the reverse
switch (2) marked with
tool will rotate in reverse
direction. Release the reverse
switch, the tool will stop.
MAIN SHAFT LOCK (FIG. D)
To manually operate the tool,
•
한국어
or
, the tool will
or "power"
, the
Advertisement
