Operation; Maintenance - Makita HK1820 Instruction Manual

Bit angle
1
008532
1
008533
The bit can be secured at 12 different angles. To change
the bit angle, slide the change ring forward, then turn the
change ring to change the bit angle. At the desired angle,
slide the change ring back to the original position. The bit
will be secured in place.
Hook
1
2
3
008530
When connecting the power supply cord to an extension
cord, use the hook so that the plug of power supply cord
cannot be disconnected from the connector of extension
cord. Set it on the extension cord 10 cm - 20 cm away
from the connector of the extension cord.

OPERATION

008527
1. Change ring
1. Change ring
1. Hook
2. Power supply
cord
3. Extension cord
6
Position the bit at the location to be chipped, then pull the
switch trigger. Apply slight pressure on the tool so that
the tool will not bounce around, uncontrolled. Pressing
very hard on the tool will not increase the efficiency.
1
2
002941
NOTE:
When removing tiles with a scaling chisel, apply the
•
chisel to the bottom of tiles as shown in the figure. If
you operate the tool with the chisel applied to the
top surface of tiles, the service life of the chisel will
be shortened.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Bull point
•
Cold chisel
•
Scaling chisel
•
Bit grease
•
Safety goggles
•
Hammer grease
•
Hook
•
1. Scaling chisel
2. Tile
or attachments
Only use accessory or
are