Panasonic CF-29 Series Reference Manual page 102

List of Error Code
Error Code/Message
0280: Previous boot incomplete -
Default configuration used
02B0: Diskette drive A error
*1
0613: Serial Port configuration
changed
*1
0614: Serial Port config. error -
device disabled
*1
The port name, such as A or B, is
displayed, indicating the conflicting
ports.
Press <F1> to resume, <F2> to
Setup
Operating System not found
Action
Startup has failed repeatedly, so the Setup Utility
settings have been returned to their default values,
and the computer has been restarted.
Run the Setup Utility and load the default values,
then change the settings to the appropriate
values as needed.
Disconnect the floppy disk drive and reconnect it.
Make sure the drive is secured correctly.
I/O address and IRQ settings are in conflict.
Run the Setup Utility and change the settings in
[Advanced] menu so there is no port conflicts.
Write down the error details and press F2 to run
the Setup Utility. Confirm the settings, and
change the settings to the appropriate values as
needed.
The OS is not properly installed on the floppy disk or
the hard disk that you are trying to boot from.
If the computer cannot be booted from the floppy
disk, make sure there are no non-bootable floppy
disks in the floppy disk drive.
If the computer cannot be booted from the hard
disk, perform the reinstallation procedure.
If the computer cannot be booted from the hard
disk, disconnect the hard disk drive and recon-
nect it again.
If the problem persists, perform the reinstallation
procedure.
If a device is connected to the USB port, discon-
nect the device, or run the Setup Utility and set
[Legacy USB Support] in [Security] menu to [Dis-
able].
102