Basic Installation And Configuration; Default Factory Settings - NETGEAR RangeMax WPN802 Reference Manual

This chapter explains how to install and configure and the WPN802 Access Point on your
network. The first time you configure the WPN802 Access Point it must be connected with an
Ethernet cable to a computer with a broadband Internet connection.

Default Factory Settings

The WPN802 default factory settings are shown below. After you install the WPN802 Access
Point, customize any of the settings to better meet your networking needs.
FEATURE
User Name (case sensitive) admin
Password (case sensitive) password
(if DHCP server is unavailable)
Broadcast Network Name (SSID) Enabled
AutoCell Enhanced RF Security 'stealth' mode Disabled
Restricting connectivity based on MAC Access

Basic Installation and Configuration

Basic Installation and Configuration
Operating Mode Access Point
Access Point Name netgearxxxxxx where xxxxxx are the last six digits of
Built-in DHCP client DHCP client disabled
SIP Configuration
Network Name (SSID) NETGEAR
802.11b/g RF Channel 6
Mode Auto 108
WEP/WPA Disabled
Control List
202-10101-01, 4 May 2005
DEFAULT FACTORY SETTINGS
the wireless access point's MAC address
IP Address: 192.168.0.231
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
Disabled
Chapter 3
3-1