Advertisement
Reference Manual for the ADSL Modem Wireless Router DG834GSP
5. Configure the DG834GSP as in the Gateway-to-Gateway procedures using the VPN Wizard
(see
"How to Set Up a Gateway-to-Gateway VPN Configuration" on page
to use appropriate network addresses for the environment.
The LAN Addresses used in this example are as follows:
Device
DG834GSP
FVL328
a. In Step 1, enter toFVL328 for the Connection Name.
b. In Step 2, enter fvl328.dyndns.org for the remote WAN's IP address.
c. In Step 3, enter the following:
•
IP Address = 172.23.9.1
•
Subnet Mask = 255.255.255.0
6. Configure the FVL328 as in the Gateway-to-Gateway procedures for the VPN Wizard (see
"How to Set Up a Gateway-to-Gateway VPN Configuration" on page
use appropriate network addresses for the environment.
a. In Step 1, enter toDG834 for the Connection Name.
b. In Step 2, enter dg834g.dyndns.org for the remote WAN's IP address.
c. In Step 3, enter the following:
•
IP Address = 10.5.6.1
•
Subnet Mask = 255.255.255.0
7. Test the VPN tunnel by pinging the remote network from a PC attached to the DG834GSP.
a. Open the command prompt (Start -> Run -> cmd)
b. ping 172.23.9.1
B-12
LAN IP Address
LAN Subnet Mask
10.5.6.1
255.255.255.0
172.23.6.1
255.255.255.0
v1.0, June 2007
8-21), being certain
8-21), being certain to
NETGEAR VPN Configuration
Advertisement
