Ip Standard Access List Settings - D-Link xStack DGS-3620 Series Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
LE (1-32)
Click the Add button to add a new entry based on the information entered.
Click the <<Back button to return to the previous window.
Click the Edit button to re-configure the specific entry.
After creating an IPv6 entry, click the
The fields that can be configured are described below:
Parameter
Sequence ID (1-
65535)
Direction
IPv6 Prefix
Address
GE (1-128)
LE (1-128)
Click the Add button to add a new entry based on the information entered.
Click the <<Back button to return to the previous window.
Click the Edit button to re-configure the specific entry.

IP Standard Access List Settings

This window is used to create an access list used to filter routes.
To view the following window, click L3 Features > IP Route Filter > IP Standard Access List Settings, as shown
below:
Enter the maximum prefix length to be matched.
View Detail
Figure 6-184 IP Prefix List Settings - View Detail (IPv6 ) window
Description
Enter the sequence number for the rule entry.
Use the drop-down menu to Permit or Deny the specified network.
Enter the IPv6 network address followed by the prefix address.
Enter the minimum prefix length to be matched.
Enter the maximum prefix length to be matched.
link to see the following window.
331