Battery Module (Battm); Installation Hardware; Base/Top Assembly; Hanger Assembly - NEC NEAX 2000 IPS Configuration Manual
Nec electronics america server user manual
Hide thumbs
Also See for NEAX 2000 IPS:
- Command manual (1038 pages) ,
- Installation manual (619 pages) ,
- System manual (448 pages)
Table of Contents
Advertisement
Chapter 3 Module and Installation Hardware
Battery Module
(BATTM)
Installation Hardware
Base/Top
Assembly
Hanger Assembly
19-inch Bracket
Optional Bracket
NEAX 2000 IPS Configuration Guide
NDA-24347, Issue 1
The BATTM is an optional module for installing optional long-term backup batteries.
These batteries provide backup protection for approximately three hours. The
BATTM is designed to accommodate batteries covering up to a 4-PIM system (two
BATTMs support maximum system configuration).
The BATTM is available for Floor-standing Installation. (When the system is a
Wall-mounting/19-inch Rack-mounting configuration, the BATTM cannot be
installed with the PIM.)
ABBR.
NAME CODE
PIMMD
SN1617 PIMMD
BATTM
SN1619 BATTMB
For the purpose of simplifying orders, a PIM includes AC/DC Power Card
Note:
and Power Cable.
The Base/Top Assembly includes a Base Unit and a Top Cover for the PIM. One
Base/Top Assembly is required for each PIM stack.
Hanger Assembly is used for Wall-mounting Installation. One set of Hanger
Assembly is required for each PIM. Refer to
Wall-mounting Installation.
The 19-inch Bracket is a set of hardware used for 19-inch Rack-mounting Installation.
•
19-inch Rack Bracket (A) is installed at both sides of the PIM. One set of 19-inch
Bracket (A) is required for each PIM.
•
19-inch Rack Bracket (B) is installed at the base of stack. One set of 19-inch
Bracket (B) is required for each stack.
If the system contains two PIMs or more with 19-inch Bracket (B), one set of 19-inch
Bracket (A) is also required for the top PIM.
Refer to
Figure 3-5
and
Installation.
A Mounting Bracket is used for Floor-standing Installation. Without a Mounting
Bracket, 1.1 G shockproof is provided for a 1- to 3-PIM stack, and 0.5 G shockproof is
provided for a stack of four or more PIMs. To enhance the shockproof capability to
Table 3-1
Modules
PART
NUMBER
150018
151120
Figure 3-6
for drawings of 19-inch Rack-mounting
Installation Hardware
REMARKS
PIM 0 ~ PIM 7
One per stack.
Maximum of two per system.
Figure 3-4
for drawings of
Page 27
Advertisement
Table of Contents
