Lan Cable Connection Of Ether Card; Neax 2000 Ips; Configuration Guide - NEC NEAX 2000 IPS Configuration Manual

Chapter 2 System Configuration

LAN Cable Connection of ETHER Card

NEAX 2000 IPS Configuration Guide
NDA-24347, Issue 1
Connect the LAN connector on the ETHER card and the Router/Switching HUB by
using a 10 BASE-T/100 BASE-TX cable.
When the system provides Dterm IP/OAI terminal/MAT on the LAN, connect them to
Switching HUB, which is connected to the LAN connector on the ETHER card.
ETHER
LAN
8
7
6
5
4
3
2
1
Pins (RJ-45 Connector)
Pins (RJ-45 Connector)
Figure 2-13 ETHER - Router/Switching HUB Cable Connection
The port number of the NEAX 2000 IPS for OAI is fixed to 60030 and for MAT
Note:
is fixed to 60000.
LAN Cable Connection of ETHER Card
100 BASE-TX Cable
Maximum 328 ft. (100 m)
Not used
Not used
RD -
Not used
Not used
RD +
TD -
TD +
Router/Switching HUB
Dterm IP
OAI
MAT
Page 23