Peripherals; System Cables; Rack Mount Kit; Converter Box - Sony DME-3000 Product Manual

SONY

Peripherals

RCC-
5G, 10G, 30G
RMM-30
DME-3000BOX
BVS-V1201
28 • • Configuration Guide
This section describes the peripheral products that can be added to a DME-3000 or
DME-7000 system.

System Cables

The RCC-series cables provide RS-422 9-pin interconnects for serial controlled
devices. Three lengths are available:
•
RCC-5G, 5 meters
•
RCC-10G, 10 meters
•
RCC-30G, 30 meters
RCC cables are required to connect the chassis to other RS-422 devices. Note that
some devices include RS-422 cables as standard.

Rack Mount Kit

The RMM-30 Rack Mount Kit allows the DME-3000 or DME-7000 to be rack-
mounted in a standard 19" rack.

Converter Box

For control panel cable lengths over 10 meters, the DME-3000BOX converts 25-
pin control to RS-422 9-pin control. The converter box requires the model AC-550
Power Supply, and the 25-pin cable supplied with the BKDM-3010 control panel.

Analog Signal Input Source Router

The BVS-V1201 Analog Signal Input Source Router accepts 12 video inputs and
provides one video output. Up to two units can be used for input source selection of
primary video and key signals. Input source control is the ability to change images
on a keyframe-by-keyframe basis or on an edge switch. Source selection may be
performed from the control panel included with the BVS-V1201, or you can use the
DME's GUI menu. An RS-422 connection is required between the BVS-V1201
and the DME chassis.
Note that RS-422 interconnect cables are not provided. See the "System Cables"
heading above for part numbers and information. RS-422 interconnect cables have
a maximum length of 100 meters.
DME-3000/7000 • Product Guide