Install Cowling; Power Trim And Tilt System - Yamaha 40V Owner's Manual

Operation
should supply oil normally. If no oil is
flowing after 10 minutes of idling, consult
your Yamaha dealer.
ECM00130
NOTICE
Be sure to take the above steps when op-
erating the engine after a long period of
storage. Otherwise engine seizure could
occur.
EMU36961

Install cowling

1. Be sure that all cowling lock levers are
released.
2. Be sure that the rubber seal is seated all
the way around the engine.
3. Place the cowling on top of the seal.
4. Check to be sure the rubber seal fits cor-
rectly all the way around the engine.
5. Move the levers to lock the cowling as
shown. NOTICE: If the cowling is not
installed correctly, water spray under
the cowling can damage the engine,
or the cowling can blow off at high
speeds.
[ECM01990]
42
After installing, check the fitting of the top
cowling by pushing it with both hands. If the
ZMU03367
top cowling is loose, have it repaired by your
Yamaha dealer.
EMU34581

Power trim and tilt system

EWM01930
WARNING
Never get under the lower unit while it
●
is tilted, even when the tilt support lever
is locked. Severe injury could occur if
the outboard motor accidentally falls.
Body parts can be crushed between the
●
motor and the clamp bracket when the
motor is trimmed or tilted.
Be sure no one is near the outboard
●
motor before performing this check.
1. Check the power trim and tilt unit for any
sign of oil leaks.
ZMU06118
ZMU04678