Panasonic DBS Section 540 Reference Manual page 19

System Planning
The actual trunk numbers used and the Network Trunk Group Numbers must
be determined for each DBS. In this example, each DBS has two sets of
trunks for network calls. These paths are assigned a Network Trunk Group
number (either Network Trunk Group 1 or Network Trunk Group 2) as shown
in Figure 2-6 below:
Figure 2-6. Example Network Trunk Group Configuration
DBS 1
1XXX
Network Trunk
Group 1
Network Trunk
Group 1
DBS 4
4XXX
DBS-2.3/9.2-540
Network Trunk Network Trunk
Group 2 Group 2
Network Trunk Network Trunk
Group 2 Group 2
T1 Networking - Revised April 2000
System Planning Forms and Guidelines
DBS 2
2XXX
Network Trunk
Group 1
Network Trunk
Group 1
DBS 3
3XXX
Page 19