1-Port Fast Ethernet Module
Connecting Fast Ethernet Ports
Use a two-pair Category 5 or unshielded twisted-pair (UTP) straight-through RJ-45 cable
to connect the RJ-45 port on a 1-port Fast Ethernet network module to a switch, hub,
repeater, server, or other network device. Figure 4-7 shows the RJ-45 port connected to a
hub.
Note
available and must be Category 5 cables.
Figure 4-7
FE–PRI
1FE-1C T1
Category 5
or UTP cable
4-6
Cisco Network Modules Hardware Installation Guide
RJ-45 cables are not available from Cisco Systems. These cables are widely
Connecting a Fast Ethernet RJ-45 Port to a Hub
10/100Bas eT
CTRLR 0
Fast Ethernet
RJ-45
EN
Fast Ethernet hub