Mount The Camera - D-Link DCS-7010L Quick Installation Manual

Mount the Camera

Please refer to the steps below to assist you with mounting the camera.
We suggest that you configure the camera before mounting.
Step 1
Position the mounting bracket
in the desired location.
Step 2
Mark the surface behind the
mounting bracket with a pencil.
Step 3
Use a 6mm drill bit to make required holes approximately 25mm deep.
Step 4
Insert wall anchors and affix the bracket using the screws provided.
6
Step 5
Ensure the cable is seated in the cable channel.
Step 6
Suspend the camera from the two protruding
7
5
studs near the top of the mounting bracket.
Step 7
Insert and tighten the remaining screw into the hole on the camera base.
6