Frequently Asked Questions - D-Link DCS-910 Quick Installation Manual

Frequently Asked Questions

Q: How do I configure my DCS-910/DCS-920 without the CD?
A: Connect your PC to the router using an Ethernet cable. Log on to D-Link support site
http://support.dlink.com.tw. Download the Setup Wizard
DCS-910/DCS-920 section under technical support. Install and run the Setup Wizard
SE utility. Your camera should be detected automatically. Either use the Wizard
included in the utility to configure the device or click on Link to access the devices
directly. The default username is 'admin'. The default password is blank. If you have
changed the password and can not remember it, you will need to reset the
DCS-910/DCS-920 to set the password back to blank (leave the field blank).
If the DCS-910/DCS-920 cannot find a DHCP server, the default IP address is
http://192.168.0.20.
Q: How do I reset my DCS-910/DCS-920 to factory default settings?
A: Ensure the DCS-910/DCS-920 is powered on. Push and hold a paperclip in the reset
hole for 10 seconds, then release it. The camera should be back to factory default
settings.
Q: If I don't have a router, how do I install the camera?
A: Connect the camera directly to the computer's Ethernet port. You need to assign your
computer a static IP address in range with the camera, such as 192.168.0.1. You can
then access and setup the device via the default IP address of http://192.168.0.20.
Q: Why does my DCS-920 not connect to my wireless network after it has been set
up?
A: After you have enabled and configured the wireless connection, disconnect the
Ethernet connection between the DCS-920 and your computer. Wait 60 seconds and
the device will connect to the configured wireless connection automatically.
For further troubleshooting, please refer to the Manual on the CD.
3
SE utility from the