Electrical Requirements; General Electrical Connections; 110-120 Volt, 60 Hz. Tool Information - RIDGID AF3000 Owner's Manual

14. Reinstall filter cover plates by slipping
tab into slots in end frame, then pivot
to side panel. Reinstall fasteners.
15. To suspend your unit at the minimum
height, five double loop sections of
chain are required (4-13/16"). Slip this
length of chain over the screw hook in
the joist, letting the excess chain hang
down in case adjustment of length is
required later.
16. Place "S" hook in bottom link of chain
at four suspension points.
17. Lift cabinet up, with help and connect
"S" hooks to eye bolts at four points in
cabinet.
18. Connect extension springs to "S"
hooks. Push unit up and connect

Electrical Requirements

General Electrical Connections

DANGER: To avoid electrocution:
1. Use only identical replacement
parts when servicing. Servicing
should be performed by a quali-
fied service technician.
2. Do not use in rain or where floor
is wet.
This tool is intended for indoor resi-
dential use only.

110-120 Volt, 60 Hz. Tool Information

NOTE: The plug supplied on your tool
may not fit into the outlet you are planning
to use. Your local electrical code may
require slightly different power cord plug
connections. If these differences exist
refer to and make the proper adjustments
per your local code before your tool is
plugged in and turned on.
In the event of a malfunction or break-
down, grounding provides a path of least
resistance for electric current to reduce
the risk of electric shock. This tool is
equipped with an electric cord having an
equipment grounding conductor and a
grounding plug, as shown. The plug must
be plugged into a matching outlet that is
upper loop of extension spring to bot-
tom loop of fourth double loop of
chain. Repeat for other three springs.
Refer to figure shown on previous
page.
19. Unit is now hung from the ceiling as
high as possible. If you prefer the unit
to hang lower, unhooking each of the
four chains from its screw hook (one
at a time), and rehooking each chain
to its screw hook on a different link
can do this. When the hanging height
is satisfactory, squeeze all four "S"
hook loops closed at the eye bolts and
chains. (Optional: For a cleaner
appearance, snip off extra length of
chain links.)
WARNING Do not permit fingers to
touch the terminals of plug when
installing or removing the plug to or
from the outlet.
If power cord is worn or cut, or damaged
in any way, have it replaced immediately.
properly installed and grounded in accor-
dance with all local codes and ordi-
nances.
Do not modify the plug provided. If it will
not fit the outlet, have the proper outlet
installed by a qualified electrician.
A temporary adapter may be used to con-
nect this plug to a 2-pole outlet, as shown,
if a properly grounded outlet is not avail-
able. This temporary adapter should be
used only until a properly grounded outlet
can be installed by a qualified electrician.
The green colored rigid ear, lug and the
like, extension from the adapter must be
connected to a permanent ground such
as a properly grounded outlet box.
7