Formatting（フォーマット - Yamaha ACD1 Service Manual

ACD1
FORMATTING
1. Starting the ACD1
Turn on the power while holding down the following two keys on the ACD1 panel. (Format mode)
[BACK] + [NEXT]
The following screen will be shown on the LCD of the ACD1 when the format mode is started.
2. Execution and confi rmation
Press the key shown below to execute or cancel formatting when the screen shown above is indicated.
[ ▲ INC/YES] : Execution
[ ▼ DEC/NO] : Cancellation
Select the "Execution" and formatting will start. The following screen will be indicated during formatting. It takes about 15 seconds
for formatting. Do not turn off the power during formatting.
The formatting is completed when the above indication disappears.
The ACD1 will restart when the "Cancellation" is selected.
After formatting
The formatted setting is enabled when the ACD1 is restarted after the formatting operation is conducted.
Execute the "Writing component" after formatting as the formatting deletes the entire component data. (Refer to page 66)
90
Format
Are you sure?
[Example of the ACD1 LCD display]
Formatting
Do not turn off
[Example of the ACD1 LCD display]