Samsung CLX-6220 Troubleshooting Manual page 20

Code
08-003
08-010
Symptom and Possible Cause
At duplex scan, the leadedge of the document has not reached to the duplex sensor after scanning the front side.
Possible Cause
1. Duplex sensor or actuator is defective.
2. There is the contamination on paper path or a defective assembly.
3. The Duplex Gate does not work properly.
4. Duplex motor is defective.
Troubleshooting method
1. Check and clean the Duplex Solenoid, replace as is necessary.
2. Check and clean the Exit Roller, replace as is necessary.
3. Check the signals from the DADF Drive Board, replace as is necessary.
Service Manual
Alignment & Troubleshooting
Error message
Original paper Jam
Original paper jam inside of scanner. Remove Jam
4-48
Samsung Electronics