Connections - Yamaha TF5 Quick Manual

Hide thumbs Also See for TF5:
Table of Contents

Advertisement

5. Connections

Connecting outputs
Powered speakers (floor monitors)
Powered speakers (front
speakers)
Default signal routing for each output jack
OMNI OUT 1
AUX1 OUT
OMNI OUT 2
AUX2 OUT
:
OMNI OUT 12
AUX12 OUT
OMNI OUT 13
MONITOR L OUT
OMNI OUT 14
MONITOR R OUT
OMNI OUT 15 (L)
STEREO L OUT
OMNI OUT 16 (R)
STEREO R OUT
Each OMNI OUT jack is configured by default to output
a bus. You can change the bus that is output on the
SYSTEM OMNI OUT PATCH screen.
The OMNI OUT jacks can be configured to output the
following signals.
AUX1–AUX20, STEREO L, STEREO R, SUB, MONITOR L,
MONITOR R, NO ASSIGN (no output signal assigned).
12
TF series Quick Guide
Connecting inputs
Default signal routing for each channel
CHANNEL
CH 1
:
:
CH 16
CH 17
:
CH 24
CH 25
:
CH 32
CH 33
:
CH 40
ST IN 1L
ST IN 1R
ST IN 2L
ST IN 2R
Default signal routing for each channel is shown above. To
change the signal routing, use the INPUT screen
(page 18).
Keyboard or synthesizer
FC5 (optional)
TF5
TF3
TF1
INPUT 1
INPUT 1
INPUT 1
:
:
:
INPUT 16
INPUT 16
INPUT 16
INPUT 17
INPUT 17
INPUT 1
:
:
:
INPUT 24
INPUT 24
INPUT 8
INPUT 25
INPUT 1
INPUT 9
:
:
:
INPUT 32
INPUT 8
INPUT 16
USB IN 1
USB IN 1
:
:
:
USB IN 8
USB IN 8
ST IN 1L
ST IN 1L
ST IN 1L
ST IN 1R
ST IN 1R
ST IN 1R
ST IN 2L
ST IN 2L
ST IN 2L
ST IN 2R
ST IN 2R
ST IN 2R
Electric guitar or bass
Mic
Computer
(DAW software)
USB 2.0
HINT
What if I'm using condenser mics?
Phantom power must be supplied to condenser mics.
Some direct boxes also need phantom power. When using
phantom power, first set "+48V Master" on the SYSTEM
SETUP screen to on, then turn phantom power on or off
for each channel on the corresponding channel's INPUT
screen. Make sure you turn phantom power off if it is not
needed. For more details, refer to the Reference Manual.
Why can't I hear anything?
• Is the fader that corresponds to the desired INPUT jack
raised?
• Does the input select for each channel match each
INPUT jack?
• Is the channel's head amp gain set too low?
• Is the channel's [ON] key pressed?
• Is the channel muted?

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tf3Tf1

Table of Contents