Makita BTD200 Instruction Manual page 12

ASSEMBLY
Installing or removing driver bit
CAUTION:
Always be sure that the tool is switched off and the battery cartridge is removed before
installing or removing the bit.
Use only the driver bit or socket bit shown
I
To install the bit, pull the sleeve in the
direction of the arrow and insert the bit into
the sleeve as far as it will go. Then release
the sleeve to secure the bit. To remove the
bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
7
- - - -
Bit Sleeve
I
Hold the tool firmly and place the point of the driver bit in the screw head. Apply forward
pressure to the tool to the extent that the bit will not slip off the screw and turn the tool
on
to
start operation.
12