Motorola Communications Gateway User Manual page 24

Introduction Before You Begin
Caution
Do not connect both the Ethernet
and USB cables to the same
computer.
P/ N : 47 62 03 - 00 1 M ad e i n T ai w an , R . O. C .
CM H F C M AC I D : A B CDE F 01 23 45
CU S TOM E R S/ N : B CD EF G HJK L MN P
S/ N : PPP P MM Y Y J J JS SSS S CK A ABB C CC C
MT A MA C I D : A B CD EF 01 23 4 5
To cable outlet
To Ethernet or USB
(connect only one to a
single computer)
To telephone lines
Home Print
Installation & Configuration
Cabling and Startup for a Single User, continued
19
To connect the telephone line(s), plug a telephone wire into one or both phone jacks.
Caution
20
To connect to the Internet, connect your computer to the Communications Gateway
To power outlet
using USB or Ethernet:
USB: Be sure the Motorola Communications Gateway CD-ROM is inserted in your
CD-ROM drive. Connect the USB cable to the USB port on the Communications
Gateway. Connect the other end to the USB port on your computer. Then perform
"Setting Up a USB Driver"
Ethernet: Connect the Ethernet cable to the Ethernet connector on the
Communications Gateway. Connect the other end to the Ethernet port on your
computer. Ethernet users do not need to set up a USB driver.
X
Exit
Troubleshooting
If you connect to a wired telephone wall jack, be sure it is not connected to
a traditional telephone (PSTN) service.
on page 21.
19
Communications Gateway User Guide
FAQ Glossary
License