Front I/O assembly
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Rotate the drive cage to its upright position
5.
Disconnect the cables from the system board as follows:
(1): Blue connector labeled FRONT USB 3.0
(2): Yellow connector labeled FRONT USB
(3): Blue connector labeled FRONT AUD
6.
Remove the cables from the cable clips under the drive cage.
7.
Remove the Torx T15 screw (1) that secures the assembly to the front of the chassis.
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page
21).
(Rotating the drive cage on page
20).
19).
32).
Front I/O assembly
51