Removing A 2.5-Inch Hard Drive - HP ProDesk 600 G2 Small Form Factor Maintenance And Service Manual

Removing a 2.5-inch hard drive

1. Prepare the computer for disassembly
2. Remove the access panel
3. Rotate the drive cage to its upright position
4. Disconnect the power cable (1) and data cable (2) from the back of the hard drive.
5. Pull outward on the release lever at the rear of the drive (1) then slide the drive back until it stops and
pull it down and out of the drive bay (2).
6. If you are installing a new drive, refer to
installing a new drive, rotate the drive cage down and replace the access panel.
(Preparation for disassembly on page
(Access panel on page 20).
(Rotating the drive cage on page
Installing a 2.5-inch hard drive on page
19).
32).
44. If you are not
Drives 43