Changing The Engine Oil - Toro power max 926 Operator's Manual

Figure 46
1. Pipe plug
3. Remove the pipe plug from the gearbox.
4. Check the oil level in the gearbox. The oil should be at
the point of overflowing at the filler opening.
5. If the oil level is low, add GL-5 or GL-6, SAE 85-95
EP gear oil lubricant to the gearbox until the point of
overflow.
Note: Do not use synthetic oil.
6. Install the pipe plug in the gearbox.
1
G016782
23

Changing the Engine Oil

Service Interval: After the first 5 hours—Change the engine
oil.
Every 50 hours—Change the engine oil.
Change the engine oil every 25 operating
hours when operating the engine under a
heavy load.
If possible, run the engine just before changing the oil because
warm oil flows better and carries more contaminants.
Use automotive detergent oil with an API service classification
of SF, SG, SH, SJ, SL, or higher. Refer to your engine owner's
manual.
Use Figure 47 below to select the best oil viscosity for the
outdoor temperature range expected:
Figure 47
Engine Oil Capacities
Model
38820
38822
38824
1. Clean the area around the oil drain cap (Figure 48).
G016496
Figure 48
1. Oil drain plug
Engine Oil Capacity
30 to 32 oz. (0.89 to 0.95 l)
1