Attaching The Stand Unit - Sharp LC-52/60LE833ELC-60LE830E Service Manual

LC-52/60LE830E,RU/831E,S/833E
[2] OPERATION MANUAL
Preparation

Attaching the stand unit

Before performing work, spread cushioning over the
surface on which you will be laying the TV. This will
prevent it from being damaged.
CAUTION
Attach the stand in the correct direction.
Be sure to follow the instructions. Incorrect
installation of the stand may result in the TV falling
over.
1
Confirm that there are screws with the stand
unit.
1 For 60 inch models
(four long screws, five middle screws and two
short screws)
2 For 52 inch models
(four long screws, four middle screws and one
short screw)
2
Attach the supporting post for the stand unit
onto the base using the long screws with a
screwdriver as shown.
60 inch models
3
Insert the stand into the openings on the bottom
of the TV (hold the stand so it will not drop from
the edge of the base area).
Make sure that the stand is firmly inserted into the
TV. Improper installation may result in tilting of the
TV set.
60 inch models
Supporting
post
52 inch models
Soft cushion
52 inch models
4
Insert and tighten middle screws into the holes
on the rear of the TV.
60 inch models
5
Attaching the stand cover.
Insert the stand cover.
1
Insert and tighten the short screw(s) into the
2
hole(s) of the stand cover.
60 inch models
NOTE
To detach the stand unit, perform the steps in reverse
order.
A screwdriver is not supplied with this product.
The TV can be rotated up to 20 degrees to the right and
left.
2 – 5
52 inch models
52 inch models