Tc3; General Characteristics; General Characteristics Wm - Electrolux TC2 Service Manual

4 TC3

4.1

GENERAL CHARACTERISTICS

The ENV06 electronic control system consists of a single
PCB, which incorporates the power, control and display
functions where the LCD display is connected and the
programme selector is incorporated in the board.
The PCB is mounted on a casing fitted to the control panel.
4.1.1

General characteristics WM

Version
TC3
(TIME MANAGER)
Version
TC3
(PROPORTIONAL)
No. buttons
No. of LEDs
Programme selector
Serial port
Power supply voltage
Washing type
Rinsing system
Motor
Spin speed
Anti-unbalancing system
Water fill
Detergent dispenser
Control of water level in the
tub
Door safety interlock
Heating element heat output
Temperature control
Buzzer
Sensors
SOI/DT 2010-03 dmm
maximum 8 (5 options + 1 start/pause + 2 for time driven)
maximum 18 + LCD display
15-21 positions with main switch (incorporated in the PCB)
DAAS-EAP communication protocol up to 115,200 baud
220/240V
50/60 Hz (configurable)
Traditional with "Eco-ball" sphere
Jet-System
Traditional with "Eco-ball" sphere
Jet-System
Collector, with tachometric generator (Universal)
Two-pole asynchronous, with three-phase tachometric generator (with
Inverter)
600 ÷ 1,600 rpm
FUCS (for universal motors)
AGS (for asynchronous motors with Inverter)
1 solenoid valve with 1 inlet – 2 or 3 outlets
3 compartments: pre-wash/stains, wash, conditioner
4 compartments: pre-wash, wash, conditioner, (bleach)
Electronic/analogue pressure switch
Traditional (with PTC)
Instantaneous
1950W with thermal fuses incorporated
NTC sensor incorporated in the heating element
Traditional incorporated in the PCB
Water fill gauge (flowmeter)
Aqua control
13/78
599 72 84-41