Scanning A Volume - D-Link DSN-1100 X Stack User Manual

Revoke Access for an iSCSI Initiator in this list. Select the iSCSI initiators to
–
which you want to deny access this volume and click Apply.
4. Record your settings in Table C-2.

3.3.2 Scanning a Volume

After you create a volume, you can scan it for errors. This task reads every block in the
volume to ensure that parity and media are correct. If parity errors are found, this task
corrects the errors.
To scan a volume:
1. In the Volume View, click a volume in the Main Display.
2. Perform one of the following steps:
On the Volumes menu, click Scan Volume.
–
Click Scan Volume in the Volume Actions panel.
–
Press the right mouse button and click Scan Volume from the shortcut menu.
–
Any of these steps displays the Scan Volume dialog box (see Figure 3-22).
xStack Storage Management Center Software User's Guide
If you revoke access, the iSCSI initiator moves below Unused Initiators if
Sort by Volume is selected in the Volume View. You can then use the
procedure in section 3.5 to remove unused iSCSI initiators if desired.
43