Adjusting Position; Auto Setup - Panasonic th-49lf8w Operating Instructions Manual

Adjusting Position

1
Press <POSITION> to display the
[Position] menu.
Position
Default Default

Auto setup

H-position
H-size
V-position
V-size
Clock phase
Dot clock
1:1 pixel mode
2
Select the item to adjust with
●
Unadjustable items are greyed out.
Adjustable items differ depending on the input
signal and the display mode.
3
Adjust with
4
Press <POSITION> to exit from adjust
mode.
■
To return to the previous screen
Press <RETURN>.
■
To reset to defaults
Press <DEFAULT> while the menu is displayed, or
press <ENTER> when [Default] is selected, then the
settings will be set to factory settings.
Note
● Set ings for [Position] are memorised separately for
each input signal.
Setting [Position] when the display is installed
vertically
When adjusting, please note that even when the
display is installed ver ically, setting directions of
position / size are the same as that of horizontal
installation.
34
English
0
0
0
0
15
0
Off
.
Auto setup
When inputting a PC signal, [H-position] / [V-position],
[H-size] / [V-size], [Clock phase] and [Dot clock] are
automatically corrected.
This setting is enabled under the following
condition:
●
When inputting from PC IN or RGB IN
While displaying the picture of the corresponding
signal, select [Auto setup] and press <ENTER>.
Using Remote Control
Press <AUTO SETUP>.
When Auto Setup does not work, [Invalid] is
displayed.
Auto mode
.
When the [PC auto setting] is set to [On] in the [Options]
menu (see page 65), automatic position adjustment
starts under the following conditions:
●
When the display power is turned ON.
●
When the input signal is switched.
Note
●
When the dot clock frequency of a PC signal is 162
MHz or higher, [Clock phase] and [Dot clock] cannot
be automatically corrected.
●
Auto Setup may not work when a cropped or dark
image is input. In such case, switch to a bright image
with borders and other objects are clearly shown,
and then try auto setup again.
● Depending on the signal, out of alignment may
occur after Auto Setup. Carry out fine tuning for the
position/size as required.
● If Auto Setup cannot set properly for XGA signal
(1024×768, 1280×768, 1366×768), pre-selecting the
individual signal in [XGA mode] (see page 45) may
results in correct Auto Setup.
●
Auto Setup does not work well when a signal such
as additional information is superimposed out
of valid image period or when intervals between
synchronizing signal and image signal are short. Also
it does not work well for image signals with tri level
synchronizing signal added, or for some SYNC ON
G signals.
●
If Auto Setup does not work well, select [Default],
press <ENTER>, and then adjust the position/size
manually.