Decode Aiming Pattern
Parameter # F0h 32h
This parameter only applies in Decode Mode. Select Enable Decode Aiming Pattern to project the aiming
pattern during bar code capture, or Disable Decode Aiming Pattern to turn the aiming pattern off.
NOTE With
Picklist Mode on page 4-10
Aiming Pattern is disabled.
*
Enable Decode Aiming Pattern
(02h)
Low Light Enhancement
Parameter # F1h 64h
In Scanstand mode, selecting Enable Low Light Enhancement causes illumination to remain on at a low
level in low lighting conditions. Select Disable Low Light Enhancement to prevent illumination from
remaining on under these conditions.
Enable Low Light Enhancement
(01h)
enabled, the decode aiming pattern flashes even when the Decode
Disable Decode Aiming Pattern
*Disable Low Light Enhancement
Decoding Preferences
(00h)
(00h)
5 - 5