Connecting The Power Cord - NEC Pinwriter P2000/P2X User Manual

Section 1
Start Here
4
Set the paper thickness setting lever according to the thickness of paper or the
number of sheets in a,multi-ply form (see Table 2-l).
Close the top cover.
NOTE: To remove the ribbon, pull up the top of the cartridge and slide the bar on the
bottom of the cartridge away from the hooks.

CONNECTING THE POWER CORD

Switch off power to the printer.
WARNING: Check that the power switch is off.
Plug the power cord into a properly grounded outlet.
Turn on the power. You can see tbe lights on the control panel altematingly
blinking (lights go off after two seconds).
CAUTION:
the power cord to the abnormal voltage outlet may cause the printer damage.
Applicable voltage is indicated on the printer label located at the back of the printer.
For more information, see Appendii A
connection and disconnection.
The type of power cord plug is
different from each voltage type.