Description of Parts
Right side
Rear side
J
H
K
A: Hard Disk Drive
Reference Manual "Hard Disk Drive"
B: SD Memory Card Slot
Reference Manual "SD Memory Card"
C: SD Memory Card Indicator
(Blinking: During access)
Reference Manual "SD Memory Card"
D: IEEE 1394 Interface Connector
Reference Manual "IEEE 1394 Devices"
E: Smart Card Slot
<Only for model with Smart Card slot>
Reference Manual "Smart Card"
F: Modem Port
Reference Manual "Modem"
G: LAN Port
Reference Manual "LAN"
H: USB Port
Reference Manual "USB Devices"
I: DC-IN Jack
J: Security Lock
A Kensington cable can be connected.
For further information, read the manual that comes
with the cable.
K: Ext Antenna Connector
L: Expansion Bus Connector
Reference Manual "Port Replicator"
M: External Display Port
Reference Manual "External Display"
10
A
L
M
N O
P
B
C D
E
F
G
H
1394
Bottom
Q
N: Headphone Jack
You can connect headphones or amplifi ed speakers.
When they are connected, audio from the internal
speakers is not heard.
O: Microphone Jack
A condenser microphone can be used. If other types
of microphones are used, audio input may not be pos-
sible, or malfunctions may occur as a result.
When recording in stereo using a stereo micro-
phone:
Double-click
tions] - [Properties], and add a check mark for [Re-
cording], click [OK] - [Options] - [Advanced Controls]
- [Advanced], remove a check mark for [Mono Micro-
phone], and then click [Close].
When using a monaural microphone with a 2-termi-
nal plug:
With the settings outlined above, only audio on the
left track will be recorded.
When monitoring the microphone audio using head-
phones, sounds on the left track cannot be heard,
regardless of the above settings. This is a result of
the computer's specifi cations, and is not a malfunc-
tion.
P: Serial Port
Q: RAM Module Slot
Reference Manual "RAM Module"
R: Speaker
Reference Manual "Key Combinations"
I
R
in the notifi cation area, click [Op-