Front Panel Indicator Lights - Mitsubishi WD-52528 Owner's Manual

Front-Panel Indicator Lights
SYSTEM
RESET LAMP STATUS TIMER
Indicators
Refer to the following tables for explanations of the front-panel indicator lights.
Power/Timer Indicator
Indicator Color TV Condition
None (indicator off)
TV is powered OFF.
Green, steady
TV is powered ON.
Green, rapid blinking 1. TV just plugged into AC outlet.
2. AC just restored after power failure.
3. TV Rebooting after System Reset
used.
4. TV Rebooting after power
fluctuation or receiving abnormal
digital signals from digital channel,
CableCARD™, or digital device.
5. You have begun the procedure to
update software from an authorized
flash memory device.
Green, slow blinking
TV powered off and automatic on-
timer is set.
Lamp Indicator
Indicator Color TV Condition
None (indicator off)
Normal TV on or standby condition.
Green, rapid blinking TV just powered off and lamp is
cooling.
Yellow, steady
Lamp nearing end of useful life.
Yellow, blinking
1. Lamp access door is open or not
secure.
2. No lamp installed.
Red, steady
Lamp no longer illuminates and has
reached the end of the lamp life.
16
Chapter 1. Television Overview
– VOL –
POWER FORMAT
– CH –
< >
ENTER
ADJUST
Additional Information
Normal operation.
Normal operation.
Wait until blinking stops before turning on
(approximately 1 minute). Normal operation.
Wait until blinking stops before turning on
(approximately 1 minute). Normal operation.
Wait until blinking stops before turning on
(approximately 1-2 minutes). Normal operation.
Wait until blinking stops before turning on
(approximately 1 minute). Normal operation.
For detailed information, see the instructions
that accompany the authorized software update.
Important: Do not use non-authorized software at
any time.
Normal operation. TV can be turned on at any time.
Additional Information
Normal operation.
Begins to blink 30 seconds after turning off TV. TV
can be turned on before it begins to blink or after the
blinking stops, but not while the indicator is blinking.
Normal operation.
This is a recommendation to have a new lamp ready
before the current lamp stops illuminating. See
Appendix H for ordering information.
TV will not operate until lamp access door is secure.
See Appendix H for installation information.
TV will not operate without a lamp. See Appendix H
for installation information.
Replace the lamp. The TV will not operate when
the lamp no longer illuminates. See Appendix H for
installation information.
MENU GUIDE DEVICE
MENU
CANCEL