Programming The Remote Control: To Control Other A/V Products - Mitsubishi VS-45609 Owner's Manual

Programming the Remote Control: To Control Other A/V Products

VCR
CABLE/DBS DVD
TV
AUDIO
1
3 DVD/LDP Player Codes
DVD/LDP brand Code to enter:
Mitsubishi (DVD) 003
Mitsubishi (LDP) 016, 017
Panasonic 250
Pioneer DVD (LDP) 252 (016, 017)
Sony 254
Toshiba 253
To reset to default code, enter 000
Figure 4. Programming the remote to control your DVD/
LDP.
VCR
CABLE/DBS DVD
TV AUDIO
1
3 A/V Receiver Codes
Audio brand Code to enter:
Mitsubishi A/V receiver
Set M-VR1000 or M-VR800 to 015
and/or CD player
Set M-VR900 or M-VR700 to 010
Denon 234, 235, 236
Kenwood 200, 208
JVC 232, 233
Onkyo 209, 214
Pioneer 205, 207
Sony 222
Yamaha 201, 208
To reset to default code, enter 000
Figure 5. Programming the remote to control your A/V
receiver.
If the slide switch is set to TV when you
enter an A/V receiver code, VOLUME
and MUTE will control the A/V receiver
rather than the TV. To return volume
and mute control to the TV, set the slide
switch to TV, press and hold POWER
and enter 000.
After entering the correct codes for each
position of the remote control, use the slide
switch to select the product to control when
POWER
an operational button is pressed. If you
enter a code from the AUDIO chart while
2
the slide switch is set to TV, the volume
and mute functions change to match the A/V
If your
receiver. This is useful when using an A/V
DVD
code is not
receiver with the TV all the time. In all
listed here,
please see
other cases, only one of the below devices
page 62
for a is allowed for each slide switch position.
complete
listing.
TV position:
TV
A/V receiver (volume and mute only)
Cable/DBS position:
Cable box
Satellite receiver
VCR position:
POWER
VCR
2
DVD position:
DVD
LD Player
If your
audio
Audio position:
code is not
listed here,
A/V receiver
please see
Mitsubishi CD player
page 62
for a
receiver, the audio position may be used in conjunction with
complete
select Mitsubishi CD players. Your audio position must be
listing.
programmed to either 010 or 011. Plug the CD player power
cord into a switched outlet on the back of your A/V receiver.
Pressing the POWER button will then turn on your A/V receiver,
in turn, turning on your CD player. On select CD players, the
transport controls (FF, Play, Rew, etc.) in the audio position will
operate the CD player.]
Some manufacturers may change their
products, or they may use more than
one remote control system. If this is the
case, your remote control may not be
able to operate your VCR, DVD, cable
box, satellite receiver, or A/V receiver.
Part III: Setup
[If you have a Mitsubishi A/V
25
25