Specifications; Save All Warnings And Instructions For Future Reference; Additional Safety Rules For Tool - Makita 2414EN Instruction Manual

ENGLISH
(Original instructions)
1 Base
2 Bolt holes
3 Lock-off button
4 Switch trigger
5 Screw
6 Spark guard
7 Socket wrench
8 Guide plate
9 Move
10 Hex bolts
11 Clamping screw
12 Safety guide
13 Shaft lock

SPECIFICATIONS

Dimensions (L x W x H)
Net weight
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting in ferrous materials with
appropriate abrasive cut-off wheel. Follow all laws and
regulations regarding dust and work area health and
safety in your country.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under unfavor-
able mains conditions can have adverse effects to the
operation of other equipment. With a mains impedance
equal or less than 0.21 Ohms it can be presumed that
there will be no negative effects. The mains socket used
for this device must be protected with a fuse or protective
circuit breaker having slow tripping characteristics.
Explanation of general view
14 O-ring
15 Inner flange
16 Ring
17 Spindle
18 Cut-off wheel
19 Outer flange
20 Hex bolt
21 Vise plate
22 Vise nut
23 Vise handle
24 Spacer block
25 Straight piece of wood (Spacer)
26 Over 45 mm long
Model
Wheel diameter
Hole diameter
–1
No load speed (min )
With under cover
With European type safety guard and under cover
Safety class
ENE007-3
ENF002-2
ENF100-1
27 Over 65 mm long
28 Over 190 mm long
29 Diameter of workpiece
30 Width of spacer block
31 Vise
32 Blocks
33 Under cover
34 Wing bolt
35 Limit mark
36 Screwdriver
37 Brush holder cap
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future
reference.

ADDITIONAL SAFETY RULES FOR TOOL

1. Wear protective glasses. Also wear hearing pro-
tection during extended periods of operation.
2. Use only wheels recommended by the manufac-
turer which have a maximum operating speed at
least as high as "No Load RPM" marked on the
tool's nameplate. Use only fiberglass-reinforced
cut-off wheels.
3. Check the wheel carefully for cracks or damage
before operation. Replace cracked or damaged
wheel immediately.
4. Secure the wheel carefully.
5. Use only flanges specified for this tool.
6. Be careful not to damage the spindle, flanges
(especially the installing surface) or bolt, or the
wheel itself might break.
7. Keep guards in place and in working order.
8. Hold the handle firmly.
9. Keep hands away from rotating parts.
10. Make sure the wheel is not contacting the work-
piece before the switch is turned on.
2414EN
355 mm
25.4 mm
3,800
500 mm x 280 mm x 620 mm
17.6 kg
/II
GEA010-1
ENB066-2
5